On Wed, May 8, 2013 at 1:00 PM, Ronald J. Yacketta <yacketrj(a)potsdam.edu>wrote:
Trying to figure out why I am not getting e-mails from profile /
system
installs. Found a patch and applied it then compared my KS file to the
default one left behind during a fresh install.
After a profile / system is installed the install.log just shows a state
of 'stop' and never gets a 'finish' which I think is why e-mails are not
being sent, am able to send e-mails from the cobbler server and not seeing
any Exceptions in cobbler.log.
==KS %post==
%post
(
$SNIPPET('log_ks_post')
echo "Post-Install section begins.."
sleep 15
$yum_config_stanza
$SNIPPET('post_install_network_config')
$SNIPPET('post_install_kernel_options')
$SNIPPET('cobbler_register')
$SNIPPET('post_anamon')
$SNIPPET('kickstart_done')
) 2>&1 | tee /root/post-install.log
%end
==install.log==
profile SL-6.3-x86_64 10.137.24.163 start 1367956120.14
profile SL-6.3-x86_64 10.137.24.163 stop 1367956688.33
==http access.log==
10.137.24.163 - - [07/May/2013:15:58:08 -0400] "GET
/cblr/svc/op/trig/mode/post/profile/SL-6.3-x86_64 HTTP/1.0" 200 4 "-"
"Wget/1.12 (linux
-gnu)"
==cobbler.log==
Tue May 7 15:58:08 2013 - INFO | REMOTE run_install_triggers; user(?)
Tue May 7 15:58:08 2013 - DEBUG | running python triggers from
/var/lib/cobbler/triggers/install/post/*
Tue May 7 15:58:08 2013 - DEBUG | running python trigger
cobbler.modules.install_post_puppet
Tue May 7 15:58:08 2013 - DEBUG | running python trigger
cobbler.modules.install_post_report
Tue May 7 15:58:08 2013 - DEBUG | running python trigger
cobbler.modules.install_post_power
Tue May 7 15:58:08 2013 - DEBUG | running python trigger
cobbler.modules.install_post_log
This should be getting fired off from the cobblerd server as a post install
trigger. You have all of the build_reporting* settings configured
correctly? These are the default values:
build_reporting_email: [root@localhost]
build_reporting_enabled: 0
build_reporting_sender: ''
build_reporting_smtp_server: localhost
build_reporting_subject: ''
build_reporting_to_address: ''