Hello,
We have upgraded to RHQ v4.13.1 from v4.11.0 a few days ago. We also went from a 3 node
storage cluster to a 5 node storage cluster. Each node runs on a separate server.
When we were starting the RHQ server instances, we encountered an issue with the
replication factor, as ours was set to '1' on the sys auth table, and the rhq
table as well (for 1 or 2 RHQ server instances). We made the change to the replication
factor to '2'. When we started the instances back up, the storage node status
showed 'joining' for 3 out of the 5 nodes. The other 2 showed 'normal'.
We checked the storage nodes, which are functioning just fine with no issues. We tried to
connect with the RHQ CLI and run cluster maintenance to see if that would change the
status in the GUI. No such luck. But again, the nodes are running just fine on the
servers as indicated by the logs, etc. How can we change this status to 'normal'?
Anything we can do in the GUI or run via the CLI aside from cluster maintenance?
Regards,
Barry Barnett
Enterprise Queuing Services | (QS4U) Open Queuing Services
Wells Fargo
Cell: 803-207-7452
Show replies by date