when i installed the guests the was one possible way in the 'advanced
options' with nat. the bridged one for eth0 and eth1 was disabled
(gray).
did i miss something or have to install something do be able to use
bridging? no matter for me if it's nat or bridge, at the end all
mashines should be in the same (open)vpn.
Am Sonntag, den 30.05.2010, 13:19 -0400 schrieb Tom Horsley:
On Sun, 30 May 2010 19:02:00 +0200
brizly vaan van Ulciputz wrote:
> the guests are behind nat (default in kvm?).
I have never seen the default KVM nat work at all,
and I suspect something about the firewall rules
it constructs interact badly with the firewall
rules I already have on my host, but I never
investigated enough to find out for sure.
I like switching to use a "bridge" network setup,
and that always works perfectly for me, my KVM machines
look just like real machines on my LAN as far as
everything else is concerned.