I had a similar problem with my office PC. It uses an i810 video card
(I'm not sure).
I fixed it updating to the latest kernel and latest xorg with yum. Try
this and report back any other issue.
However there is a problem switching to different virtual terminals with
Ctrl + Alt + Fn. Every time I switch X crashes. This problem has
always been present in that specific hardware. I used to have Mandrake
9 in there and it had the very same problem. FC3 doesn't fix that.
-William
El dom, 26-12-2004 a las 19:32 -0600, Francisco Mendez escribió:
Hi:
I have installed FC3 on a machine with the following:
P iii @ 800 MHz
Motherboard Intel D815EEA
512 MB of Ram
This machine is working with the integrated video card: (extract from
lspci):
...
00:02.0 VGA compatible controller: Intel Corp. 82815 CGC [Chipset
Graphics Controller] (rev 02) (prog-if 00 [VGA])
Subsystem: Intel Corp.: Unknown device 4541
Flags: bus master, 66Mhz, medium devsel, latency 0, IRQ 11
Memory at f8000000 (32-bit, prefetchable) [size=64M]
Memory at ffa80000 (32-bit, non-prefetchable) [size=512K]
Capabilities: [dc] Power Management version 2
...
After instalation all that I get is a black screen with previous
colored garbage displays. After several attempts and reboots, the
firstboot program tried to start but unsuccesfully.
At the time I'm running FC1 on this machine, and thought it was time
to move to FC3.
Is there a possibility to run FC3 on this machine?
Thx in advance for your help.
Francisco Mendez
--
fedora-list mailing list
fedora-list(a)redhat.com
To unsubscribe:
http://www.redhat.com/mailman/listinfo/fedora-list