[root@Home ~]# iwconfig eth1
eth1 unassociated ESSID:off/any
Mode:Managed Channel=0 Access Point: 00:00:00:00:00:00
Bit Rate=0kb/s Tx-Power=off
RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@Home ~]#
On Thu, 30 Dec 2004 10:35:44 -0400, Patrick Boutilier
<boutilpj(a)ednet.ns.ca> wrote:
<snip>
>>
>
>
> Update
> i have the driver installed...it is listed as one of my devices eth1
> shows intel 2200bg when i go to activate it, says can't acquire an
> ip and to check the to see if the "Cable is unplugged" umm hello
> it's wireless !!!
> so where do i go from here? firmware is installed, as mentioned
> before, where do i install the wireless tools? whats this about
> turnning on the radio in my kernel?
>
> the instructions to build this driver read like sterio
> instructions... they're all over the place so i don't know which end
> is up.
> link for instructions
http://ipw2200.sourceforge.net/INSTALL
>
> i'm close (I think) to getting this to work
> thanks
What does
iwconfig eth1
say?
--
fedora-list mailing list
fedora-list(a)redhat.com
To unsubscribe:
http://www.redhat.com/mailman/listinfo/fedora-list
--
James Lawrence
Rochester NY