On 03/21/2014 05:43 PM, Ed Greshko wrote:
On 03/22/14 07:39, CS_DBA wrote:
> On 03/21/2014 05:33 PM, Ed Greshko wrote:
>> On 03/22/14 06:07, CS_DBA wrote:
>>> I can plug a hard wire into my laptop and boot up, it comes up connected.
>>>
>>> I can boot up with no connection and then tell it to connect to the wireless
it works fine, but if later I click disconnect for the wireless and plug the hard wire
(cat 6) cable in it says it's "connecting" but spins until I finally
reboot.
>> Have you tried unplugging the cable, waiting a bit, and plugging it in again?
>>
> Seems to work fine, but when I try and move from wireless to em1 "on the
fly" I see the issue
I don't quite understand.... Are you saying.....
You boot up with no connection and then tell it to connect to the wireless it works fine.
You then disconnect from wireless, plug in the cable, status becomes
"connecting" but never connects. Then, you uplug the cable, wait a bit, plug it
back in....and all is well.
Is that what you are doing/seeing? You don't need to reboot...but you do need to
plug-in, plug-out, plug-in?
Here's what I see
1) If I boot up with no cable plugged in it auto connects to the
wireless immediately
2) If I boot up with the cable (cat 5/6) plugged in it immediately
connects to em1
3) If I boot with the cable plugged in, then unplug the cable it
connects to the wireless quickly
4) If I boot up with the cable plugged in, disconnect the cable, then
re-connect it it re-connects to em1 fine
5) however if I boot up with no cable, let it connect to the wireless,
then plug in the cable it attempts to connect to em1 but never completes