On Thu, 2004-05-27 at 17:37, Anthony Presley wrote:
supported, at all (any change in this?), so I went out a picked up a
Netgear WG511, 802.11g. This card uses the prism54 module / driver, and
works VERY well if I do not use WEP.
However, if I'm using WEP, it doesn't work at all. It cannot fetch an
IP address, or anything. The hex key is being stored in
/etc/sysconfig/networking/devices/keys-eth1, in the format:
KEY=s:XXXXXXXXXXXXX
Is WEP working with prism54? What about on the 64-bit kernel?
I'm not using that particular card but I do have a DWL-G650 card working
with the prism54 drivers using WEP just fine. This is on a Dell
Latitude CPx laptop with FC2.
My keys-eth0 file does not have the s: in the key. That may be the
problem.
--
Scot L. Harris <webid(a)cfl.rr.com>