Les Mikesell wrote:
Les wrote:
> A straight magnet can mess it up a bit, but I don't know about total
> erasure. Generally degaussing takes an AC field, such as that from the
> degausing strip around a TV set or monitor (you degause tube type
> monitors and tv's to keep the color guns from being biased and giving
> fringes around the images). And a hard disk drive is "saturation" type
> recording, and some of the new ones use a very deep form of recording
> that is different from the surface recording done on magnetic tape. So
> if you wish to degauss a drive (remove all forms of data including
> formatting and bad sector stuff), then a very high strength degaussing
> platform is needed. Or a 5 lb or heavier hammer applied with gusto to
> the platters seems to do a pretty thorough job, unless you are
> discussing state secrets or the next advent of computing.
Or use that hammer to drive a small steel punch all the way through the
drive. It's quick and someone would have to be pretty determined to get
any data back after that.
The newer platters are much harder as we found out when we tried to cut
some drives up with a metal saw. To hard.
I read an article of using "Coke" (I prefer Pepsi) and drill a few holes
in the top of the case. Fill with Coke and let sit. Soon the surface
of the platters are now etched.
I was going through some old drives and destroying them. I ended up
just drilling holes and soaking them in water. Destroyed the circuit
boards with a hammer as well.
It would be interesting what size of magnetic field is necessary to
fully erase a drive still in it's case.
I did find this.
http://www.darkreading.com/document.asp?doc_id=97378
--
Due to the move to Exchange Server,
anything that is a priority, please phone.
Robin Laing