(f-38; stand-alone work station; nvidia graphics card; dual monitor;
kmod 4xx driver)
I just finished doing a "dnf upgrade" as a prerequisite step to
upgrading from f-38 to f-39.
There were no hints of any problems. The kernel and the graphics driver
were replaced during this "dnf upgrade".
The akmods did finish before I rebooted.
The shutdown took 5 minutes because it ran akmods (a second time?!).
During the boot-up, there was a message that it was failing back to nouveau.
The display is not working properly; only one monitor is being used and
everything is oversized in the display.
I am not comfortable proceeding with the f-38 to f-39 upgrade with the
work station in this condition.
Important: I have only one old kernel. I have no rescue kernel.
How do I get this workstation working properly?