Mario Gomes (mgomes(a)eol.ca) said:
I've installed Severn onto a Shuttle SK41G. Below are the specs
for the
motherboard taken from the Shuttle website:
FX41
CPU Socket : AMD Socket A, support 266/200MHz FSB CPU
Chipsets : North bridge-VIA KM266, South bridge-VIA 8235
Memory : Spoort DDR 266/200 * 2
On Board VGA : VIA Savage8, 8-32 MB VGA share memory
On Board Audio : Realtek ALC650 support 5.1 channel audio, Support n/Out
Expansion Slot : PCI * 1, AGP * 1
IDE interface : ATA-133
I was able to install Severn in text mode to the point that the computer
reboots. The problem arises when the reboot is processing, eventually
the screen goes blank and I get this error message:
out of range
26Hz / 21Khz
I suspect that the monitor frequency is incorrectly set and I somehow
need to change this before the system starts loading. The monitor I
have is a GEM LCD and the frequency recommended is (H) 30Khz-60Khz and
(V) 50Hz-75 Hz. I would appreciate if someone has any suggestions on
how to correct this problem.
If you boot with 'nogui', and then try to start X, is that when it
goes out of spec?
Bill