my computer boot only in emergency mode ...
Looking the journalctl (command journalctl -xb), I found (in thejournalctl
) these lines in red color :
ATA2:00: link is slow to respond....
ATA200: SRST failed (erro 16)
That seem indicate that it is a problem to access the HDs..
I found a possible solution to the problem in this post:
There is wrote that :...the problem can depend by the physic set up of the
HD (as "master", "slave", "single drive", ...): this set up
can be done by
changing the position of a jumper on the HD...
I know that, in the past time, the HDs had to be set physically in this
way.., but recently I never heart anymore that the modern HD need this
So actually I don't care anymore of the configuration of the HDs
(my HD is Toshiba 1 TB that I bought few mounts ago).
I would like to have a confirmation that what I read in the post is only an
obsolete information and, in any case, I would like to know also what I can
do to go around in my problem..
From the command line: ls /dev/sd* I get:
give me this input :
/dev/sda /dev/sda1 /dev/sda2 /dev/sda5 /dev/sdb /dev/sdb1