On 03/07/06, Les Mikesell <lesmikesell(a)gmail.com> wrote:
> Up until here, everything is clear. I also agree that the
router
> shouldn't be droping packets.
Where is 'here'? If you run traceroute you should see
each hop separately.
'Here' is up until this point in the letter :)
The rest gets confusing.
I took your '1.5Mbs' connection to mean a T1 which would
normally
be an interface directly on a router. If you have a separate
modem, perhaps you have DSL instead. Anyway, wiring problems
are rare but possible. More likely is a duplex mismatch where
one end is set to full duplex and one to half. Check that on
both the router and PC first. On the linux side, ifconfig will
show errors and total transmits/receives but you have to do some
math to compute bandwidth or you can run something like gkrellm
to show it as a graph. mii-tool or ethtool will show the
speed and duplex settings.
I'm on a cable connection. Cable Coming Into House Through Hole In
Wall -> Modem -> Router -> Linbox.
I'll look into the duplex problem, but where do I start? I did a bit
of googling but I apparently don't know which keywords to google. How
can I check linux's duplex setting, and how can I check the routers?
Here, this may help:
$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:C1:26:02:91:50
inet addr:192.168.123.131 Bcast:192.168.123.255 Mask:255.255.255.0
inet6 addr: fe80::2c1:26ff:fe02:9150/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:90596 errors:0 dropped:0 overruns:0 frame:0
TX packets:82693 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:88603039 (84.4 MiB) TX bytes:12217393 (11.6 MiB)
Interrupt:11 Base address:0xf00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:24 errors:0 dropped:0 overruns:0 frame:0
TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1532 (1.4 KiB) TX bytes:1532 (1.4 KiB)
Did you do a 'yum update' immediately after the install? And
if
you have ssh enabled and reachable from inbound connections, do
you have a complex password that would be difficult to guess?
The machine is completly up-to-date.
Try to find something that shows traffic and errors on the router
side. And if the errors are on the next hop out past the router,
report that to your isp.
Wouldn't mtr do that? But I need to correct or eliminate the router first.
Dotan Cohen
http://song-lirics.com