ethtool result..........
ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: Not reported Advertised auto-negotiation: No Speed: 10Mb/s Duplex: Half Port: MII PHYAD: 32 Transceiver: internal Auto-negotiation: off Current message level: 0x00000000 (0) Link detected: no
2009/9/12 Jorge Fábregas jorge.fabregas@gmail.com
On Saturday 12 September 2009 02:01:33 pm sureshbabu ct wrote:
eth0: 10 Mbit, half duplex, no link
If I remember well..even if the interface drops to half-duplex, you shouldn't see "no link" on the mii-tool output. Does "ethtool eth0" show no link as well? Did you check the LED on the card? Is the port on the switch configured auto or manually? That's what I would do...
HTH, Jorge
-- fedora-list mailing list fedora-list@redhat.com To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines