ethtool result..........


 ethtool eth0
Settings for eth0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  Not reported
        Advertised auto-negotiation: No
        Speed: 10Mb/s
        Duplex: Half
        Port: MII
        PHYAD: 32
        Transceiver: internal
        Auto-negotiation: off
        Current message level: 0x00000000 (0)
        Link detected: no


2009/9/12 Jorge Fábregas <jorge.fabregas@gmail.com>
On Saturday 12 September 2009 02:01:33 pm sureshbabu ct wrote:
> eth0: 10 Mbit, half duplex, no link

If I remember well..even if the interface drops to half-duplex, you shouldn't
see "no link" on the mii-tool output.  Does "ethtool eth0" show no link as
well?  Did you check the LED on the card? Is the port on the switch
configured auto or manually? That's what I would do...



--

        (¨`·.·´¨)    with
         `·.¸(¨`·.·´¨)    Luv
        (¨`·.·´¨)¸.·´   Suresh Vellinezhi.
         `·.¸.·´