After yum update to kernel-2.6.12-1.1387_FC4, my laptop Compaq nx9005 dosen't boot. messages are:
root (hd0,1) Filesystem type is ext2fs, partition type 0x83 kernel /vmlinuz-2.6.12-1.1387_FC4 ro root=LABEL=/ rhgb quiet [Linux-bzImage, setup=0x1e00, size=0x18d7d9] initrd /initrd-2.6.12-1.1387_FC4.img [Linux-initrd @ 0xddd1000, 0x10e936 bytes]
Uncompressing Linux... Ok, booting the kernel. Warning: ATI Radeon IGP Northbridge is not yet fully tested.
The last message, "Warning: ATI ..." has been displayed sinse older kernel.
I removed "rhgb quiet" from kernel command line and got these messages:
...snip... ALI15X3: IDE controller at PCI slot 0000:00:10.0 ACPI: PCI interrupt 0000:00:10.0[A]: no GSI - using IRQ 0 PCI: setting IRQ 0 as level-triggered ALI15X3: chipset revision 196 ALI15X3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x8080-0x8087, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x8088-0x808f, BIOS settings: hdc:pio, hdd:pio
So, it seems an ACPI IRQ probing problem. I added "acpi=off" to kernel command line, the laptop booted well. But, I'm not very happy because power is won't off when shutdown...
On Sat, 2 Jul 2005 15:04:51 +0900 Kazutoshi Morioka morioka@at.wakwak.com wrote:
After yum update to kernel-2.6.12-1.1387_FC4, my laptop Compaq nx9005 dosen't boot. messages are:
root (hd0,1) Filesystem type is ext2fs, partition type 0x83 kernel /vmlinuz-2.6.12-1.1387_FC4 ro root=LABEL=/ rhgb quiet [Linux-bzImage, setup=0x1e00, size=0x18d7d9] initrd /initrd-2.6.12-1.1387_FC4.img [Linux-initrd @ 0xddd1000, 0x10e936 bytes]
Uncompressing Linux... Ok, booting the kernel. Warning: ATI Radeon IGP Northbridge is not yet fully tested.
The last message, "Warning: ATI ..." has been displayed sinse older kernel.
-- fedora-list mailing list fedora-list@redhat.com To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
Kazutoshi Morioka wrote:
I removed "rhgb quiet" from kernel command line and got these messages:
...snip... ALI15X3: IDE controller at PCI slot 0000:00:10.0 ACPI: PCI interrupt 0000:00:10.0[A]: no GSI - using IRQ 0 PCI: setting IRQ 0 as level-triggered ALI15X3: chipset revision 196 ALI15X3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x8080-0x8087, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x8088-0x808f, BIOS settings: hdc:pio, hdd:pio
So, it seems an ACPI IRQ probing problem. I added "acpi=off" to kernel command line, the laptop booted well. But, I'm not very happy because power is won't off when shutdown...
On Sat, 2 Jul 2005 15:04:51 +0900 Kazutoshi Morioka morioka@at.wakwak.com wrote:
After yum update to kernel-2.6.12-1.1387_FC4, my laptop Compaq nx9005 dosen't boot. messages are:
root (hd0,1) Filesystem type is ext2fs, partition type 0x83 kernel /vmlinuz-2.6.12-1.1387_FC4 ro root=LABEL=/ rhgb quiet [Linux-bzImage, setup=0x1e00, size=0x18d7d9] initrd /initrd-2.6.12-1.1387_FC4.img [Linux-initrd @ 0xddd1000, 0x10e936 bytes]
This is the portion that I had the hangup at. Others referred to the need to boot with acpi=off - which is not possible on this computer. Since your error is similar to mine, I'm guessing that you need acpi and this kernel version is useless in its present state. I boot runlevel 3 on the installation that is inflicted with this kernel version and can confirm a like effect.
Jim
My Dell Dimension 4500 desktop also failed to boot after upgrading to kernel-2.6.12-1.1387_FC4. I was able to boot successfully by disabling acpi as suggested below, but the less-drastic solution of only adding the parameter "pci=noacpi" to the kernel command line also works. I didn't try "acpi=noirq", perhaps that would work, too.
--Mike
Kazutoshi Morioka wrote:
I removed "rhgb quiet" from kernel command line and got these messages:
...snip... ALI15X3: IDE controller at PCI slot 0000:00:10.0 ACPI: PCI interrupt 0000:00:10.0[A]: no GSI - using IRQ 0 PCI: setting IRQ 0 as level-triggered ALI15X3: chipset revision 196 ALI15X3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x8080-0x8087, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x8088-0x808f, BIOS settings: hdc:pio, hdd:pio
So, it seems an ACPI IRQ probing problem. I added "acpi=off" to kernel command line, the laptop booted well. But, I'm not very happy because power is won't off when shutdown...
On Sat, 2 Jul 2005 15:04:51 +0900 Kazutoshi Morioka morioka@at.wakwak.com wrote:
After yum update to kernel-2.6.12-1.1387_FC4, my laptop Compaq nx9005 dosen't boot. messages are:
root (hd0,1) Filesystem type is ext2fs, partition type 0x83 kernel /vmlinuz-2.6.12-1.1387_FC4 ro root=LABEL=/ rhgb quiet [Linux-bzImage, setup=0x1e00, size=0x18d7d9] initrd /initrd-2.6.12-1.1387_FC4.img [Linux-initrd @ 0xddd1000, 0x10e936 bytes]
Uncompressing Linux... Ok, booting the kernel. Warning: ATI Radeon IGP Northbridge is not yet fully tested.
The last message, "Warning: ATI ..." has been displayed sinse older kernel.
-- fedora-list mailing list fedora-list@redhat.com To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
Kazutoshi Morioka wrote:
After yum update to kernel-2.6.12-1.1387_FC4, my laptop Compaq nx9005 dosen't boot. messages are:
root (hd0,1) Filesystem type is ext2fs, partition type 0x83 kernel /vmlinuz-2.6.12-1.1387_FC4 ro root=LABEL=/ rhgb quiet [Linux-bzImage, setup=0x1e00, size=0x18d7d9] initrd /initrd-2.6.12-1.1387_FC4.img [Linux-initrd @ 0xddd1000, 0x10e936 bytes]
Uncompressing Linux... Ok, booting the kernel. Warning: ATI Radeon IGP Northbridge is not yet fully tested.
The last message, "Warning: ATI ..." has been displayed sinse older kernel.
I filed a bug report on this(severity=high), since my own Compaq laptop also has boot problems with this kernel.
The kernel halts during IDE probing, always at the same place. I'm about to try the vanilla 2.6.12.2, but haven't finished configuring it, yet.
Please see bug report for details.
https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=162269
Øyvind.