I receive the following error message when trying to either boot to
kernel-2.6.6-1.435.2.3 or using the FC2 install DVD (kernel 2.6.5, I
think?):
SCSI subsystem initialized
Loading sd_mod.ko module
Loading scsi_transport_spi.ko module
Loading sym53c8xx.ko module
sym0: <1010-33> rev 0x1 at pci 0000:00:08.0 irq 193
sym0: using 64 bit DMA addressing
sym0: Symbois NVRAM, ID7, Fast-80, LVD, parity checking
sym0: open drain IRQ line driver, using on-chip SRAM
sym0: using LOAD/STORE-based firmware
sym0: handling phase mismatch from SCRIPTS
sym0: SCSI BUS has been reset
scsi0: sym-2.1.18j
Vendor: QUANTUM Model: ATLAS_V_18_WLS Rev: 0230
Type: Direct-Access ANSI SCSI revision: 03
sym0:6:0: tagged command queuing enabled, command queue depth 16.
scsi(0:0:6:0): Beginning Domain Validation
sym0:6: wide asynchronous
sym0:6:0: ABORT operation started
sym0:6:0: ABORT operation timed-out
sym0:6:0: DEVICE RESET operation started
sym0:6:0: DEVICE RESET operation timed-out
sym0:6:0: BUS RESET operation started
sym0: SCSI BUS reset detected
sym0: SCSI BUS has been reset
sym0:6:0: BUS RESET operation complete
sym0:6:0: ABORT operation started
sym0:6:0: ABORT operation timed-out
sym0:6:0: HOST RESET operation started
sym0: SCSI BUS has been reset
<hangs here>
I've tried to make sure everything is terminated properly, using both
"auto" scsi termination as well as manual termination. No change.
This problem does not occur with FC1 (2.4 kernel), and I have seen
other reports of this type to the LKML related to SCSI with 2.6:
http://lkml.org/lkml/2004/6/5/2
and here:
http://ronmon.shacknet.nu/configs/scsi_boot_error
but no clear solution to the problem is given. Is there a
fix/workaround for this, other than "stick with 2.4"?
Regards,
Tim