Hi all,
Just try to mount USB key 256M on my FC2 box. I have kernel modules
like usb_storage, sg, vfat, sd_mod, scsi_mod.
When plug in I see:
scsi2 : SCSI emulation for USB Mass Storage devices
Vendor: OTi Model: Flash Disk Rev: 2.00
Type: Direct-Access ANSI SCSI revision: 02
sda: Unit Not Ready, sense:
Current : sense = 70 6
ASC=28 ASCQ= 0
Raw sense data:0x70 0x00 0x06 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00
0x00 0x28 0x00 0x00 0x
00 0x00 0x00
sda : READ CAPACITY failed.
sda : status=1, message=00, host=0, driver=08
Current sd: sense = 70 6
ASC=28 ASCQ= 0
Raw sense data:0x70 0x00 0x06 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00
0x00 0x28 0x00 0x00 0x
00 0x00 0x00
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
sda: unknown partition table
Attached scsi removable disk sda at scsi3, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi3, channel 0, id 0, lun 0, type 0
USB Mass Storage device found at 4
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
---------------------------------------------------------------------
So the command:
# mount -t vfat /dev/sda1 /mnt/usbkey
gives me the error:
mount: /dev/sda1 is not a valid block device
But when I try:
# mount -t vfat /dev/sda /mnt/usbkey (yes, /dev/sda instead of /dev/sda1)
it works !
Any explanations ?
Thank you in advance
--
Quy NGUYEN DAI
http://vnoss.org/forum/