Jeffrey Ross wrote:
What am I missing when creating a raid 1 configuration. I added a new disk to the system (/dev/sda) and put the old disk as /dev/sdb (these are SATA drives)
I built a new system on /dev/sda (/ = /dev/sda6, /var = /dev/sda5, /usr=/dev/sda6, /boot=/dev/sda1, and swap=/dev/sda3) and I left roughly 300 GB for /home at /dev/sda7. I did the following: fdisk and set /dev/sda7 to type fd (/dev/sda7 2569 48641 370081341 fd Linux raid autodetect) mdadm --create /dev/md7 --level=1 --raid-devices=2 /dev/sda7 missing (I'm planning to add /dev/sdb7 upon successful creation) mkfs -V -t ext3 /dev/md7 e2label /dev/sdb2 /home1 e2label /dev/md7 /home created a simple entry in /etc/mdadm.conf with "MAILADDR root"
next copied all my user data from /dev/sdb2 (my former /home partition) to /dev/md7. This worked fine.
Then when I rebooted the system, /dev/md7 was gone and the system mounted /dev/sda7 as /home
Where did I go wrong?
Thanks, Jeff
I found my answer, or at least part of my answer. I ended up creating an additional line in /etc/mdadm.conf that said "ARRAY /dev/md7 devices=/dev/sda7"
On a previously installed system (FC6) I only had the single line "MAILADDR" and everything else was identified properly. One big difference was all the partitions were mirrored including /boot and / and the boot line specified "root=/dev/md6" Is it because the root partition was a raid that the the raid partitions were automatically assembled previously?
Thanks, Jeff