Hello,
I've compiled a kernel from:
https://github.com/jwrdegoede/linux-sunxi
I attached the .config to the mail in case is needed.
this config file i got it from:
https://github.com/cubieboard/cubie_configs/blob/master/kernel-configs/3....
This are the commands i used to compile the kernel in my laptop:
make ARCH=arm menuconfig
make ARCH=arm CROSS_COMPILE=arm-none-eabi- -j5 uImage modules
put the modules in a local directory:
make ARCH=arm INSTALL_MOD_PATH=../modules/fedora modules_install
cd ../modules/fedora
tar -zc lib > modules_3.15.tar.gz
copied the uImage and the modules to a running cubietruck, added the
kernel to
the extlinux.conf
and booted usign a serial cable but this was all i got:
Retrieving file: /uImage-3.15
4631624 bytes read in 512 ms (8.6 MiB/s)
no console=
append: enforcing=0 ro root=UUID=b487fc2a-226b-4b85-a435-a259656fb9e7
console=ttyS0,115200
Retrieving file:
/dtb-3.16.0-0.rc7.git1.1.fc22.armv7hl/sun7i-a20-cubietruck.dtb
21639 bytes read in 2139 ms (9.8 KiB/s)
Bad Linux ARM zImage magic!
## Booting kernel from Legacy Image at 42000000 ...
Image Name: Linux-3.15.0+
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 4631560 Bytes = 4.4 MiB
Load Address: 40008000
Entry Point: 40008000
Verifying Checksum ... OK
## Flattened Device Tree blob at 50000000
Booting using the fdt blob at 0x50000000
Loading Kernel Image ... OK
Loading Device Tree to 4fff7000, end 4ffff486 ... OK
Starting kernel ...
and it hanged.
can somebody give me a hint on what i'm doing wrong?
thanks!
--
Iván Chavero
Hacker