On Thu, Mar 15, 2018 at 3:59 AM, Leah Anderson
<anderson.leahandrea(a)gmail.com> wrote:
Hi. I have hopefully an easy question but has anyone gotten Fedora 27
aarch64 to work on the Pine Rock64 (
https://www.pine64.org/?page_id=7147)? I installed the
image using the instructions at
https://fedoraproject.org/wiki/Architectures/AArch64/F27/Installation. Specifically I made
sure to set --target=pine64_plus. The image I pulled was from
https://alt.fedoraproject.org/alt/ and was the minimal image. Based on this
(
https://nullr0ute.com/2017/11/overview-of-aarch64-sbc-support-in-fedora-27/) I saw that a
serial connection was required but unfortunately I can't seem to get that piece to
work. I did also flash an Ubuntu image just to make sure I had the jumpers correct for the
serial connection and that did work as expected. I also made sure to set enable_uart=1 in
config.txt. Any thoughts would be greatly appreciated :)
The Rock64 and Pine64 boards are completely different and the process
you followed is for the later which won't work with the former.