On Fri, Jan 2, 2015 at 12:38 AM, Craig Lanning
<craig.t.lanning(a)gmail.com> wrote:
I have an A10S-OlinuXino-MICRO board.
I loaded Fedora 20 on it before 21 was available and it worked fine. It
would use the HDMI monitor as its display.
You used the F-20 remix
I tried Fedora 21 on it today. I followed the F21 installation
instructions that said to write the image to the SD card and then copy
the U-Boot image for the specific card to the appropriate place. For
the Place I used the same instructions as given for the other A10 and
A20 boards.
So that bit appears to have worked just fine.
This booted up and wrote messages to the serial port. It ended with
a
login prompt. If I tried to enter a username via the terminal emulator,
nothing happened. It didn't seem to get any characters. So I plugged a
USB keyboard into it, but to no avail. It recognized that I had plugged
a keyboard in, but wouldn't use anything I typed.
Is there additional configuration that I missed?
We don't currently support displays as there is no upstream support
for HDMI. If you used a disk image other than the minimal one the
initial-setup comes up on the graphical display. You need to use the
minimal image and then the initial-setup will come up on the serial
console and you can create users, set TZ etc.
Peter