Hi,
Am 21.12.18 um 08:01 schrieb Zamir SUN:
Tested against Fedora 28 aarch64 on RPi3. Unfortunately I have
negative
feedback.
I was happily running kernel-4.19.4-200.fc28.aarch64 with wifi before
the update. But after the update and reboot, wifi disappeared. Moreover,
reboot back to kernel-4.19.4-200.fc28.aarch64 also did not help.
i assume you have a 3 B not a B+.
Can you provide a complete dmesg?
[root@rpi3 ~]# ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state
UP group default qlen 1000
link/ether b8:27:eb:a2:a9:f1 brd ff:ff:ff:ff:ff:ff
inet 192.168.129.8/25 brd 192.168.129.127 scope global dynamic
noprefixroute eth0
valid_lft 3563sec preferred_lft 3563sec
inet6 fe80::f6b0:a847:88c7:1fe7/64 scope link noprefixroute
valid_lft forever preferred_lft forever
[root@rpi3 ~]# nmcli device wifi list
[root@rpi3 ~]# dmesg | egrep -i "brcm|firmware"
[ 4.408297] raspberrypi-firmware soc:firmware: Attached to firmware
from 2018-09-21 15:44
[ 21.876808] platform regulatory.0: Direct firmware load for
regulatory.db failed with error -2
[ 22.058065] brcmfmac: probe of mmc1:0001:1 failed with error -110
[ 22.100755] brcmfmac: probe of mmc1:0001:2 failed with error -110
[ 22.101025] usbcore: registered new interface driver brcmfmac
[ 32.708983] bluetooth hci0: Direct firmware load for
brcm/BCM43430A1.hcd failed with error -2
[ 32.726479] Bluetooth: hci0: BCM: Patch brcm/BCM43430A1.hcd not found
Interesting the wifi chip is found, so the devicetree bugfix is working.
So this seems to be a different a issue.
Does Fedora provide the necessary Bluetooth firmware?
Would be interesting to see what happends after providing the bluetooth
firmware.
Regards
Stefan