On Thu, 2004-07-22 at 17:11 -0500, Harry Putnam wrote:
I'm posting some comments as I go thru an install. Probably not
bugzilla material but some small suggestions.
Choosing auto partition with a workstation install. I never saw
anyway to have a look at the auto created partition setup.
I've reached the installation part now and don't know yet what my
partition look like.
Maybe one can back up after auto partition and chose manual to see
what was done? But it seems there should be point where you are just
shown what was done. Would be usefull if for some reason the auto
setup was'nt adequate for users needs.
My memory may be a little fuzzy as it has been a couple of days since I
did my FC3T1 install, but I recall that on the page where you select
whether to do the auto or manual setup there was a checkbox that allowed
you to edit/verify the partitions selected. I do not remember exactly
what the working is, but I know there is something on that page because
I used it :)