On Sun, 31 Oct 2010 19:16:28 -0430
"Patrick O'Callaghan" <pocallaghan(a)gmail.com> wrote:
I just did a fresh install of F14-RC1 (i.e. the gold version,
x86_64)
with default options and have no network. My F13 system on the same
h/w and net had no problems. This is a bog-standard wired Ethernet
using DHCP to a Belkin hub. The net itself is fine as other machines
can connect, but F14 is dead. The "Edit Connections" dialogue is
completely normal, IPv4, DHCP for everything etc.
The LAN interface is an onboard Intel e1000. The kernel module is
loaded. Running "ifup eth0" (after "ifdown") times out after 90
seconds.
Attempting to run nm-applet gives a mysterious message about "Could
not get the session bus". It then dumps core.
This is about as uncomplicated a setup as it's possible to imagine,
and yet it doesn't work out of the box. Suggestions would be welcome.
poc
PS Sending from my F13 netbook on the exact same network.
HI,
I have the same problem, only slightly different system.
Interesting may be that dmesg |grep eth0 comes up with
"no ipv6 routers found"
Googling gave no insight.
Is this a kernel error message?
Henk