-----Original Message-----
From: binarynut(a)comcast.net
Sent: Mon, 02 Dec 2013 17:25:29 -0500
To: test(a)lists.fedoraproject.org
Subject: Re: Printing problems
On 12/02/2013 05:20 PM, Antonio Olivares wrote:
> Dear folks,
>
> I have installed Fedora 20 beta from netinstall cd. Printing was
> automagically set up. I print out a website, and it hangs, and prints a
> page with :
>
> ERROR:
> invalidaccess
> OFFENDING COMMAND:
> filter
> STACK:
> /SubFileDecode
> endstream
> 0
> --nostringval--
> --nostringval--
> 9
> false
>
> I had Fedora 18 successfully printing and previous versions of Fedora
> with no problems. Advice, suggestions, comments are greatly
> appreciated.
>
>
> Best Regards,
>
>
> Antonio
>
> NOTE:
> have looked for a troubleshooter, not found any. Turn off and on the
> printer and I can print one page and that is it. Then I try to print
> again and it does not work :(
>
> ____________________________________________________________
> Send any screenshot to your friends in seconds...
> Works in all emails, instant messengers, blogs, forums and social
> networks.
> TRY IM TOOLPACK at
http://www.imtoolpack.com/default.aspx?rc=if2 for
> FREE
>
>
What make of printer do you have.
And after you printed the one page do you have a Selinux icon in System
Tray on panel bar below.
--
"HP LaserJet 1200 Series", and no Selinux icon[troubleshooter] shows up :)
Best Regards,
Antonio
____________________________________________________________
FREE 3D EARTH SCREENSAVER - Watch the Earth right on your desktop!
Check it out at