Greets all;
I just ran a make xconfig on that fresh install of test3 on my shop
box as I wanted to turn on a full fledged ISA bus scan since there
are two custom made 8 bit ISA cards containing a few relays and
apparently a whole 8 bit wide input port per card, and while I have
what appears to be normal fonts elsewhere, all I get on the xconfig
screen are gfx chars, little boxes of various shapes and half,
quarter, and full moons in a character sized box.
That box isn't on a network allthough it may be eventually when I can
figure out howto get some cat5 run to the shop building. I hate
digging ditches, been there, done that once already for power out
there.
Running gnome of course since there is apparently no terminals
available if I switchdesk to kde. And it sure don't look like the
kde I'm looking at here!
How can I fix these fubared characters?
--
Cheers, Gene
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
99.22% setiathome rank, not too shabby for a WV hillbilly
Yahoo.com attorneys please note, additions to this message
by Gene Heskett are:
Copyright 2004 by Maurice Eugene Heskett, all rights reserved.