hi Wu,
the information you need is below:
[root@localhost selinux]# sestatus SELinux status: enabled SELinuxfs mount: /selinux Current mode: enforcing Mode from config file: enforcing Policy version: 24 Policy from config file: targeted
[root@localhost selinux]# rpm -q selinux-policy selinux-policy-3.7.19-195.el6_4.3.noarch
[root@localhost selinux]# rpm -q libvirt libvirt-0.10.2-18.el6_4.4.x86_64
[root@localhost selinux]# egrep -v ^# /etc/libvirt/qemu-sanlock.conf auto_disk_leases=0 require_lease_for_disks=0
在 2013-05-15 14:55:49,"Mark Wu" wudxw@linux.vnet.ibm.com 写道:
On 05/15/2013 02:00 PM, Mars gu wrote:
hi all, my Engine version is 3.1.2. and my Vdsm version is 4.10.3-10. I created a VM and tried to run it, then some error occoured, the error log is below: Exit message: internal error unsupported configuration: Read/write, exclusive access, disks were present, but no leases specified The libvirt domain XML did not have <lease> elements which created by vdsm. Must I enable auto_disk_leases in /etc/libvirt/qemu-sanlock.conf and manually set host id in qemu-sanlock.conf ?
Could you please provide the following information?
Do you enable selinux on the vdsm host? If yes, then what's the version of selinux-policy? (rpm -qi selinux-policy)
What's your configuration in qemu-sanlock.conf? (egrep -v ^# /etc/libvirt/qemu-sanlock.conf)
What's your libvirt version?
Thanks. Mark.
_______________________________________________ vdsm-devel mailing list vdsm-devel@lists.fedorahosted.orghttps://lists.fedorahosted.org/mailman/listinfo/vdsm-devel