hi Wu,
the information you need is below:
[root@localhost selinux]# sestatus
SELinux status: enabled
SELinuxfs mount: /selinux
Current mode: enforcing
Mode from config file: enforcing
Policy version: 24
Policy from config file: targeted
[root@localhost selinux]# rpm -q selinux-policy
selinux-policy-3.7.19-195.el6_4.3.noarch
[root@localhost selinux]# rpm -q libvirt
libvirt-0.10.2-18.el6_4.4.x86_64
[root@localhost selinux]# egrep -v ^# /etc/libvirt/qemu-sanlock.conf
auto_disk_leases=0
require_lease_for_disks=0
ÔÚ 2013-05-15 14:55:49£¬"Mark Wu" <wudxw@linux.vnet.ibm.com> дµÀ£º
On 05/15/2013 02:00 PM, Mars gu wrote:
hi
all£¬
my Engine version is 3.1.2. and my Vdsm version is
4.10.3-10.
I created a VM and tried to run it, then some error
occoured, the error log is below:
Exit message: internal error unsupported
configuration: Read/write, exclusive access, disks were
present, but no leases specified
The libvirt domain XML did not
have <lease> elements which created by vdsm. Must I
enable auto_disk_leases in /etc/libvirt/qemu-sanlock.conf and manually set host id in qemu-sanlock.conf ?
Could you please provide the following information?
Do you enable selinux on the vdsm host? If yes, then what's the
version of selinux-policy? (rpm -qi selinux-policy)
What's your configuration in qemu-sanlock.conf? (egrep -v ^#
/etc/libvirt/qemu-sanlock.conf)
What's your libvirt version?
Thanks.
Mark.
_______________________________________________
vdsm-devel mailing list
vdsm-devel@lists.fedorahosted.org
https://lists.fedorahosted.org/mailman/listinfo/vdsm-devel