On 5/27/14, 4:54 PM, Jackson, George C III CTR DISA PEO-MA (US) wrote:
Simon,
Actually it still doesn't work with the latest
scap-security-guide-0.5.0-InitialDraft.tar.gz I downloaded directly from the
git repo this morning. If I use the oscap from Red Hat's
openscap-1.0.8-1.el6_5.x86_64 with the cmd line of:
oscap xccdf eval --profile stig-rhel6-server-upstream --results
hera101-results.xml --report hera101-report.html --cpe
/usr/share/xml/scap/ssg/content/ssg-rhel6-cpe-dictionary.xml
/usr/share/xml/scap/ssg/content/ssg-rhel6-xccdf.xml
I still get:
Profile "stig-rhel6-server-upstream" was not found.
If I do the same with --profile stig-server or --profile server I get output
on a few checks but then error out with
OpenSCAP Error: Selector ID(ensure_logrotate_activated) does not exist in
Benchmark. [xccdf_policy.c:1904]
Selector ID(service_postfix_enabled) does not exist in Benchmark.
[xccdf_policy.c:1904]
So I went back to the oscap I compiled which didn't give any errors but every
check gave a "Result: notapplicable". I compiled with:
./configure --enable-cce --enable-sce
so I still don't know what I'm doing wrong. Any ideas?
The .tar.gz of SSG you mentioned is well over 18 months old. Mind
sharing where you nabbed it (the link should probably be taken down)?
Are you able to use the latest SSG RPM? Download instructions at:
https://fedorahosted.org/scap-security-guide/wiki/downloads