cc-ing netcf-devel
On 06/05/2011 11:09 AM, Lionel Schaub wrote:
I have already post this bug here https://bugzilla.redhat.com/show_bug.cgi?id=709734
but I did not answer.
Description of problem:
- The execution of the command "virsh iface-start br1" (br1 interface is
obtained with "virsh iface-define") takes 10 minutes.
- After restarting the machine, the interface does not start automatically
even though I specified the parameter <start mode="onboot"/>. I have to
manually run the command "virsh iface-start br1".
If I create the interface with virt-manager, I have the same problems and the
process takes about 20 minutes.
Version-Release number of selected component: I have found the 0.8.8 version of libvirt and virsh in this repository: https://fedoraproject.org/wiki/Virtualization_Preview_Repository https://fedoraproject.org/wiki/Virtualization_Preview_Repository. I use this version because the 0.8.3 has a third bug.
Fedora 14
Linux Kernel 2.6.35.13-91.fc14.x86_64
libvirt 0.8.8
virsh 0.8.8
virt-manager 0.8.7
bridge-utils 1.2
Steps to Reproduce:
- Create the file bridgeInterfaceConfig.xml (change interface, ip and mac
to
correspond to your configuration)
<interface type='bridge' name='br1'>
<start mode="onboot"/> <protocol family='ipv4'> <ip address='192.168.1.15' prefix='24'/> </protocol> <bridge> <interface type='ethernet' name='eth2'> <mac address='00:1b:21:43:36:b0'/> </interface> </bridge>
</interface>
launch "virsh iface-define bridgeInterfaceConfig.xml"
launch "iface-start br1". this step take 10 minutes.
restart the computer and see that the br1 interface no longer exists.
you can do the same with virt-manager.