I've done this before -- you can go into the server's
replication settings and set it to be a master, and then
initialize the consumer to re-replicate. Works fine.
Cool, thanks for the heads up, will give it a go when it gets a bit
quiet here later on :)
(plus after I've backed up my data again too :)
Dan
--
Dan Hawker
Linux System Administrator
Astrium
http://www.astrium.eads.net
--
This email (including any attachments) may contain confidential and/or privileged
information or information otherwise protected from disclosure. If you are not the
intended recipient, please notify the sender immediately, do not copy this message or any
attachments and do not use it for any purpose or disclose its content to any person, but
delete this message and any attachments from your system. Astrium disclaims any and all
liability if this email transmission was virus corrupted, altered or falsified.
---------------------------------------------------------------------
Astrium Limited, Registered in England and Wales No. 2449259
Registered Office: Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England