Allen Kistler wrote:
Mike Cloaked wrote:
> Bruno Wolff III wrote:
>> You should be able to once X starts. I have done this recently in order
>> to do other things. Initially there is a graphic looking screen, but I
>> don't believe it is X based. You enter locale information and then the
>> look of the screen should change significantly. At that point you should
>> be able to get to a shell prompt.
>
> Ahh - that may be the case but I seem to remember that you have to define
> the source for the install at an early stage and before the screen
> changes?
> I think that to define the network install is about the 3rd selection
> after
> Language and Keyboard selection. So changing to X probably happens when
> the
> map comes up to select the time zone? I may tinker with this on another
> machine when I move from f11 to F12 - but it would be nice if the option
> to
> tinker a little more deeply with network settings was available at an
> early
> stage in the anaconda set of steps - I know it is an unusual need during
> install though. Mostly I don't have a need to switch MAC address from
> that
> on the NIC but in this case I did need to.
The initial graphical screen is the one that just says "Fedora" and has
a "Next" button. You can get to a shell prompt from there.
The only other thing before that is the text-based screen that asks if
you want to do a media check. You can switch away during language and
keyboard ("locale") selection, too.
Anyway, I've never tried to configure the network from the command line
in the installer, so I can't say you'll actually be able to do that
(without getting overridden later). But the shell is on tty2. The GUI
is on tty6 to get back.
Thanks for that - I may have a go at that when I transition the same machine
from F11 to F12 - in the meantime I tried Bruno's suggested technique after
the install was complete - by going to a shell and as root typing the three
commands - it worked but I also had to change the MAC address in the
NetworkManager connections editor before it would connect - so I am not sure
if this same technique would work during install even if I can get to a
shell at an early stage -
However it is worth a test at some point.
--
View this message in context:
http://www.nabble.com/F11-install---can-I-change-nic-mac-address-DURING-i...
Sent from the Fedora Test List mailing list archive at
Nabble.com.