Michal Jaegermann wrote, On 10/31/2008 11:37 AM:
On Fri, Oct 31, 2008 at 09:31:28AM -0600, Michal Jaegermann wrote:
> On Fri, Oct 31, 2008 at 01:21:10PM +0100, Roger Grosswiler wrote:
>> ok. i downloaded the following from koji and gonna install this this night:
>> 1) libbdevid-python-6.0.69-1.fc10.i386.rpm
>> 2) nash-6.0.69-1.fc10.i386.rpm
>> 3) mkinitrd-6.0.69-1.fc10.i386.rpm
>> 4) kernel-firmware-22.214.171.124-69.fc10.noarch.rpm
>> 5) kernel-126.96.36.199-69.fc10.i686.rpm
>> Can i use rpm -U for others than the kernel or is -i more secure?
[ignoring signature issues]
If you have a current (older) kernel that boots and works, you probably want
to use -i with the rpm command with the kernels (only) vs -U because -U would
remove the old working kernels...
I am not sure if the below yum commands will obey the install only kernel
settings you normally get with yum, but I suspect they might.
Oops! Sending too fast. Sorry. Make the above into "localupdate":
yum --nogpgcheck localupdate *6.0.69-1.fc10*
yum --nogpgcheck localupdate k*188.8.131.52-69.fc10*
Crane Division, Naval Surface Warfare Center (NSWC Crane)
Harnessing the Power of Technology for the Warfighter