--- 2.6.12-1.1451_FC5.txt 2005-08-05 10:33:58.000000000 -0700 +++ 2.6.12-1.1451_FC5.hda-none.txt 2005-08-05 10:39:02.000000000 -0700 @@ -1,17 +1,13 @@ -/dev/hda: - multcount = 16 (on) +/dev/sda: IO_support = 0 (default 16-bit) - unmaskirq = 0 (off) - using_dma = 0 (off) - keepsettings = 0 (off) readonly = 0 (off) readahead = 256 (on) - geometry = 16383/255/63, sectors = 117210240, start = 0 + geometry = 7296/255/63, sectors = 117210240, start = 0 Filesystem 1K-blocks Used Available Use% Mounted on -/dev/hda2 19236340 11502516 6756672 63% / -/dev/hda1 101086 21646 74221 23% /boot +/dev/sda2 19236340 11502584 6756604 63% / +/dev/sda1 101086 21646 74221 23% /boot /dev/shm 253684 0 253684 0% /dev/shm /dev/dm-1 24770940 4240712 19271940 19% /home /dev/dm-0 4128448 2838084 1080652 73% /home/dickson/Mail @@ -35,8 +31,8 @@ battery 9413 0 ac 4805 0 ipv6 267905 10 -ohci1394 41609 0 pcmcia 41209 0 +ohci1394 41609 0 ieee1394 302521 1 ohci1394 yenta_socket 23629 1 rsrc_nonstatic 13249 1 yenta_socket @@ -69,9 +65,9 @@ ext3 134345 4 jbd 86233 1 ext3 dm_mod 58333 3 -ata_piix 9541 0 +ata_piix 9541 4 libata 47817 1 ata_piix -sd_mod 20929 0 +sd_mod 20929 5 scsi_mod 147369 2 libata,sd_mod Linux version 2.6.12-1.1451_FC5 (bhcompile@bugs.build.redhat.com) (gcc version 4.0.1 20050729 (Red Hat 4.0.1-6)) #1 Thu Aug 4 13:55:38 EDT 2005 @@ -106,18 +102,19 @@ ACPI: PM-Timer IO Port: 0x1008 Allocating PCI resources starting at 20000000 (gap: 20000000:c0000000) Built 1 zonelists -Kernel command line: ro root=LABEL=/ rhgb quiet +Kernel command line: ro root=LABEL=/ hda=none rhgb quiet +ide_setup: hda=none Initializing CPU#0 CPU 0 irqstacks, hard=c046c000 soft=c046b000 PID hash table entries: 2048 (order: 11, 32768 bytes) -Detected 1596.185 MHz processor. +Detected 1596.156 MHz processor. Using pmtmr for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 506456k/515916k available (2596k kernel code, 8988k reserved, 704k data, 172k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. -Calibrating delay using timer specific routine.. 3196.79 BogoMIPS (lpj=6393588) +Calibrating delay using timer specific routine.. 3196.74 BogoMIPS (lpj=6393496) Security Framework v1.0.0 initialized SELinux: Initializing. SELinux: Starting in permissive mode @@ -210,7 +207,7 @@ Simple Boot Flag at 0x79 set to 0x1 apm: BIOS not found. audit: initializing netlink socket (disabled) -audit(1123263066.316:1): initialized +audit(1123263399.716:1): initialized Total HugeTLB memory allocated, 0 VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) @@ -223,7 +220,7 @@ pci_hotplug: PCI Hot Plug PCI Core version: 0.5 ACPI: CPU0 (power states: C1[C1] C2[C2] C3[C3] C4[C3]) ACPI: Processor [CPU0] (supports 8 throttling states) -ACPI: Thermal Zone [THM] (43 C) +ACPI: Thermal Zone [THM] (49 C) isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Real Time Clock Driver v1.12 @@ -243,15 +240,15 @@ Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx Probing IDE interface ide0... -hda: IC25N060ATMR04-0, ATA DISK drive +hdb: IRQ probe failed (0xfcfa) +hdb: IRQ probe failed (0xfcfa) Probing IDE interface ide1... hdc: TSSTcorpCD-RW/DVD-ROM TSL462C, ATAPI CD/DVD-ROM drive -ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 +Probing IDE interface ide2... +Probing IDE interface ide3... +Probing IDE interface ide4... +Probing IDE interface ide5... ide1 at 0x170-0x177,0x376 on irq 15 -hda: max request size: 1024KiB -hda: 117210240 sectors (60011 MB) w/7884KiB Cache, CHS=16383/255/63 -hda: cache flushes supported - hda: hda1 hda2 hda3 hda4 hdc: ATAPI 24X DVD-ROM CD-R/RW drive, 1536kB Cache Uniform CD-ROM driver Revision: 3.20 ide-floppy driver 0.99.newide @@ -283,14 +280,27 @@ ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 5 PCI: setting IRQ 5 as level-triggered ACPI: PCI Interrupt 0000:00:1f.2[B] -> Link [LNKB] -> GSI 5 (level, low) -> IRQ 5 -ata: 0x1f0 IDE port busy ata: 0x170 IDE port busy -ata_piix: probe of 0000:00:1f.2 failed with error -16 +PCI: Setting latency timer of device 0000:00:1f.2 to 64 +ata1: SATA max UDMA/133 cmd 0x1F0 ctl 0x3F6 bmdma 0xBFA0 irq 14 +ata1: dev 0 cfg 49:0f00 82:746b 83:7fe8 84:4023 85:f469 86:3c48 87:4023 88:203f +ata1: dev 0 ATA, max UDMA/100, 117210240 sectors: lba48 +ata1(0): applying bridge limits +ata1: dev 0 configured for UDMA/100 +scsi0 : ata_piix + Vendor: ATA Model: IC25N060ATMR04-0 Rev: MO3O + Type: Direct-Access ANSI SCSI revision: 05 +SCSI device sda: 117210240 512-byte hdwr sectors (60012 MB) +SCSI device sda: drive cache: write back +SCSI device sda: 117210240 512-byte hdwr sectors (60012 MB) +SCSI device sda: drive cache: write back + sda: sda1 sda2 sda3 sda4 +Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 device-mapper: 4.4.0-ioctl (2005-01-12) initialised: dm-devel@redhat.com -kjournald starting. Commit interval 5 seconds -EXT3-fs: mounted filesystem with ordered data mode. input: PS/2 Mouse on isa0060/serio1 input: AlpsPS/2 ALPS GlidePoint on isa0060/serio1 +kjournald starting. Commit interval 5 seconds +EXT3-fs: mounted filesystem with ordered data mode. SELinux: Disabled at runtime. SELinux: Unregistering netfilter hooks Floppy drive(s): fd0 is 1.44M @@ -311,7 +321,7 @@ PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:00:1e.2[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11 PCI: Setting latency timer of device 0000:00:1e.2 to 64 -intel8x0_measure_ac97_clock: measured 55336 usecs +intel8x0_measure_ac97_clock: measured 55362 usecs intel8x0: clocking to 48000 hw_random: cannot enable RNG, aborting ACPI: PCI Interrupt 0000:00:1d.7[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11 @@ -361,11 +371,11 @@ cs: IO port probe 0x4000-0x5fff: clean. pcmcia: parent PCI bridge Memory window: 0xdfd00000 - 0xdfdfffff pcmcia: parent PCI bridge Memory window: 0x20000000 - 0x21ffffff +ieee1394: Initialized config rom entry `ip1394' cs: IO port probe 0xc00-0xcff: excluding 0xcf8-0xcff cs: IO port probe 0x800-0x8ff: clean. -cs: IO port probe 0x100-0x4ff: clean. +cs: IO port probe 0x100-0x4ff: excluding 0x3f0-0x3f7 cs: IO port probe 0xa00-0xaff: clean. -ieee1394: Initialized config rom entry `ip1394' ohci1394: $Rev: 1299 $ Ben Collins ACPI: PCI Interrupt 0000:03:01.1[B] -> Link [LNKC] -> GSI 9 (level, low) -> IRQ 9 ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[9] MMIO=[dfdfc800-dfdfcfff] Max Packet=[2048] @@ -389,10 +399,9 @@ md: autorun ... md: ... autorun DONE. cdrom: open failed. -cdrom: open failed. -EXT3 FS on hda2, internal journal +EXT3 FS on sda2, internal journal kjournald starting. Commit interval 5 seconds -EXT3 FS on hda1, internal journal +EXT3 FS on sda1, internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS on dm-1, internal journal @@ -400,7 +409,7 @@ kjournald starting. Commit interval 5 seconds EXT3 FS on dm-0, internal journal EXT3-fs: mounted filesystem with ordered data mode. -Adding 1959920k swap on /dev/hda3. Priority:-1 extents:1 +Adding 1959920k swap on /dev/sda3. Priority:-1 extents:1 b44: eth0: Link is up at 100 Mbps, half duplex. b44: eth0: Flow control is off for TX and off for RX. eth0: no IPv6 routers present