On 06/13/2012 12:03 PM, Adam Williamson wrote:
So it sounds like, right now, what you can do is take an existing
bridged config, drop NM_CONTROLLED=no from the ifcfg files, enable the
NM service if necessary, and then see if NM takes over properly. It
doesn't seem to be explicitly stated, but reading between the lines, the
UI stuff isn't done yet.
I just tried this, and NetworkManager didn't bring up either the
physical interface or the bridge. Here are ifcfg-eth0 and ifcfg-br0:
DEVICE=eth0
ONBOOT=yes
TYPE=Ethernet
IPV6INIT=no
HWADDR=00:22:4d:4f:c7:ed
BRIDGE=br0
#NM_CONTROLLED=no
IPADDR=172.31.250.1
GATEWAY=172.31.250.254
NETMASK=255.255.255.0
DEVICE=br0
ONBOOT=yes
TYPE=Bridge
IPV6INIT=no
DELAY=0
#NM_CONTROLLED=no
Anyone have any ideas?
--
========================================================================
Ian Pilcher arequipeno(a)gmail.com
"If you're going to shift my paradigm ... at least buy me dinner first."
========================================================================