--- RHEL6/transforms/shorthand2xccdf.xslt | 12 ++++++++++++ 1 files changed, 12 insertions(+), 0 deletions(-) diff --git a/RHEL6/transforms/shorthand2xccdf.xslt b/RHEL6/transforms/shorthand2xccdf.xslt index 84a68ed..1008492 100644 --- a/RHEL6/transforms/shorthand2xccdf.xslt +++ b/RHEL6/transforms/shorthand2xccdf.xslt @@ -205,6 +205,7 @@ <xsl:if test="fileperms-check-macro or fileowner-check-macro or filegroupowner-check-macro">it does not</xsl:if> <xsl:if test="partition-check-macro">no line is returned</xsl:if> <xsl:if test="service-disable-check-macro">the service is running</xsl:if> + <xsl:if test="xinetd-service-disable-check-macro">the service is running</xsl:if> <xsl:if test="service-enable-check-macro">the service is not running</xsl:if> <xsl:if test="package-check-macro">the package is installed</xsl:if> <xsl:if test="module-disable-check-macro">no line is returned</xsl:if> @@ -406,6 +407,17 @@ <xhtml:pre><xsl:value-of select="@service"/> is stopped</xhtml:pre> </xsl:template> + <xsl:template match="xinetd-service-disable-check-macro"> + To check that the <xhtml:code><xsl:value-of select="@service"/></xhtml:code> service is disabled in system boot configuration, run the following command: + <xhtml:pre># chkconfig <xhtml:code><xsl:value-of select="@service"/></xhtml:code> --list</xhtml:pre> + Output should indicate the <xhtml:code><xsl:value-of select="@service"/></xhtml:code> service has either not been installed, or has been disabled, as shown in the example below: + <xhtml:pre># chkconfig <xhtml:code><xsl:value-of select="@service"/></xhtml:code> --list +<xhtml:code><xsl:value-of select="@service"/></xhtml:code> off</xhtml:pre> + </xsl:template> + + + + <xsl:template match="service-enable-check-macro"> Run the following command to determine the current status of the <xhtml:code><xsl:value-of select="@service"/></xhtml:code> service:-- 1.7.1