Hello Jim,
OK, now I understand. I thought the email from the other person was a direct
contact to you. As I understand this is more a forum where problems are
reported and / or discussed. Am I right?
In this case do not unsubscribe. But if the content of the mailing list is
for public please unsubscribe.
BTW Is there a routine to communicate with the RS232 directly. Means to set
single pins like DRS or TDX?
Kind Regards,
Klaus Holstein
-----Ursprüngliche Nachricht-----
Von: openapc-bounces(a)lists.fedorahosted.org
[mailto:openapc-bounces@lists.fedorahosted.org] Im Auftrag von Jim Hart
Gesendet: Montag, 16. Februar 2015 07:08
An: openapc(a)lists.fedorahosted.org
Betreff: Re: AW: Having problem with STL files in BeamConstruct
Klaus,
there is no such thing like a wrong email server configuration, either you
subscribed to this mailing list some time ago or you are using an email
address
somebody else used for this mailing list before. At the bottom of each mail
there are information about the mailing list where you can unsubscribe. I'll
do
this for you, please confirm unsbuscription as soon as you recevie the
related
mail.
Jim
On 16 February 2015 at 07:08 "Klaus.Holstein"
<klaus.holstein(a)t-online.de>
wrote:
Hello Jim,
Sorry, but the problem with the wrong email address still exist.
Please check your email server because I am not amused to see email from
other customers from openapc!
This should not happen.
Best Regards,
Klaus