Dear "team" developers and users,
Is it possible to configure VLANs, say: VLAN2 and VLAN3 on top of team with
enslaved interfaces say eth0 and eth1, in such a way, that:
1. when only one interface is up, all the traffic goes through that interface;
2. when both interfaces are up, VLAN2 traffic goes through eth0 while VLAN3
traffic goes through VLAN3?
This (requested) behaviour is a little bit similar to the bonding mode 1 -
active/backup. The difference is that there is no single "global" active
interface, instead each VLAN has its active interface defined irrespective of
other VLANs. Looking from the side of enslaved interfeces - any given
interface is not definitely in an active or backup state, but rather, for a
group of VLANs is active while being in backup state for the other VLANs.
Kind regards,
--
Bartosz Lis
[pl] Instytut Informatyki Politechniki Łódzkiej
[en] Institute of Information Technology, Lodz University of Technology
Wolczanska 215
90-924 Lodz, Poland
phone: +48(42)6312796
fax: +48(42)6303414
email: bartosz.lis(a)ics.p.lodz.pl
Show replies by thread