On Sun, Jul 26, 2015 at 9:39 AM, Masami Ichikawa <masami256(a)gmail.com> wrote:
I tried to rebuild kernel from kernel-4.2.0-0.rc3.git3.1.fc23.src.rpm
but I got following error.
Applying: lib/cpumask: Make CPUMASK_OFFSTACK usable without debug dependency
Applying: amd-xgbe-a0: Add support for XGBE on A0
Applying: amd-xgbe-phy-a0: Add support for XGBE PHY on A0
Applying: arm64: avoid needing console= to enable serial console
Applying: usb: make xhci platform driver use 64 bit or 32 bit DMA
Applying: arm64: acpi drop expert patch
Applying: ARM: tegra: usb no reset
error: drivers/usb/core/hub.c: does not exist in index
Patch failed at 0007 ARM: tegra: usb no reset
The copy of the patch that failed is found in:
When you have resolved this problem, run "git am --continue".
If you prefer to skip this patch, run "git am --skip" instead.
To restore the original branch and stop patching, run "git am --abort".
error: Bad exit status from /var/tmp/rpm-tmp.yWoA78 (%prep)
Failed patch is this.
drivers/usb/core/hub.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index 43cb2f2e3b43..7f838ec11c81 100644
@@ -4996,6 +4996,13 @@ static void hub_event(struct work_struct *work)
+ /* Don't disconnect USB-SATA on TrimSlice */
+ if (strcmp(dev_name(hdev->bus->controller), "tegra-ehci.0") == 0)
+ if ((hdev->state == 7) && (hub->change_bits == 0)
+ (hub->event_bits == 0x2))
+ hub->event_bits = 0;
/* Lock the device, then check to see if we were
* disconnected while waiting for the lock to succeed. */
I did following command to rebuild on fedora 23(x86_64) environment.
rpmbuild -bp --target=$(uname -m) kernel.spec
We'd likely need to see the whole log. Also, why are you rebuilding
something that is already built on koji? Normally that is done if
someone makes modifications, so I'm curious if you have done so.