I just upgraded from FC1 to FC2 and for some reason my soundcard was not
set up properly.
Running /usr/bin/system-config-soundcard detected it and solved the
problem for the current session, but after rebooting the kernel-module
was not started.
Also running # modprobe snd-ens1370 fixed the problem for the current
session but it did not persist after rebooting.
Where should I make changes to load this at each boot time?
contents of: /etc/modprobe.conf
# Note: for use under 2.4, changes must also be made to modules.conf!
alias eth0 tulip
alias usb-controller uhci-hcd
alias snd-card-0 snd-ens1370
install sound-slot-0 /sbin/modprobe --first-time --ignore-install
sound-slot-0 && { /bin/aumix-minimal -f /etc/.aumixrc -L >/dev/null
2>&1
|| :; }
remove sound-slot-0 { /bin/aumix-minimal -f /etc/.aumixrc -S >/dev/null
2>&1 || :; } ; /sbin/modprobe -r --first-time --ignore-remove
sound-slot-0
contents of: /etc/modules.conf
alias eth0 tulip
alias usb-controller usb-uhci
alias sound-slot-0 es1370
post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L
/dev/null 2>&1 || :
pre-remove sound-slot-0
/bin/aumix-minimal -f /etc/.aumixrc -S
/dev/null 2>&1 || :
# Note: for use under 2.6, changes
must also be made to modprobe.conf!
or should I just put the modprobe snd-ens1370 in /etc/rc.local?
Thanks for your help.