pbrobinson commented on the pull-request: `Add packages needed to support aarch64 single
board computers` that you are following:
Hah, OK. Just briefly though then - in this scenario does classical
grubby update the grub2 config? And u-boot is actually an EFI binary or something? If
there's a link to more information about this setup (or perhaps an interactive shell?
I briefly glanced at
but it looks
like there's no aarch64 )
It's the exact same process used for all other grub efi upgrades.
U-boot it not an EFI binary, it's a firmware/bios (similar to say EDK2/tianocore EFI
reference implementation used in the virt stacks), it had the ability to execute EFI
binaries such as shim/grub2 etc, it can run shell and I believe now even passes a bunch of
the EFI testsuite.
I suppose at some point I need to get one of these boxes to actually
play with it locally.
It works on a RPi3 or Pine64 and will for a bunch more SBCs in F-28, feel free to msg me
directly about anything else, prob a bit off topic for this ticket
To reply, visit the link below or just reply to this email