On 12/3/18 12:45 AM, Peter Robinson wrote:
On Mon, 3 Dec 2018, 11:25 Robert Moskowitz <rgm(a)htt-consult.com
Perhaps I am spoiled with the Cubieboards,
I really like the specs of the Odroid HC1, other than its power draw
(peaks at 4A) and UART serial (got to get an expensive 1.8V unit).
But can I set it up with the partitions on the sata drive and only
uboot on the uSD?
I believe the SATA on those is USB-3 attached. Assuming the SoC has
USB3 support etc upstream in U-Boot it should be fine, there's been a
few others on list with them so hopefully they'll speak up. You might
also look at list archives for information
I have gone through the list, searching for 'odroid' and also found the
If I use the uboot for the odroid-xu3 from F30, do I still need the
hardkernel's bootloader on the uSD card?
Also do I need the appends:
|sed -i "s|append|& cpuidle.off=1 \
console=tty1 console=ttySAC2,115200n8 \
rd.driver.pre=ledtrig-heartbeat,xhci-plat-hcd no_bL_switcher|" \
I see people have gotten / onto the sata drive. Once Get it to boot
from the SD,. I will work on booting from the sata...
thanks for any input.