Thanks. That sounds like a good idea, but I still need an arm compiler.
I was hoping to cross compile on my x86 system.
To do the build, you could setup a QEMU to emulate your ARM board. It
will be faster than trying to compile on your 920T (it is something
like 64 Mb and 400 Mhz, i suppose). If i remenber correctly, it is an
armv4t (Thumb instruction set)
Once you have you QEMU up and runnig, install development tools (gcc,
rpmbuild, ... ) and rebuild your packages with following command :
rpmbuild --target armv4tl --rebuild name.src.rpm
i hope this help.
2009/3/12, Gregg Lebovitz <gregg(a)ics.com>:
> I am new to this list.
> I have an embedian boad with a Samsung S3C2440 32-bit ARM920T Core using
> an ARMv4 instruction set. Has anyone build fedora-core-10 for this
> processor? Is this a reasonable thing to do?
> I don't see instructions anywhere on how to do the build myself. I have
> downloaded all the source rpms, but down know how to get the build
> started. Any help will be appreciated. I scanned the mail list archive
> and didn't seem to find anything on how to get started.
> fedora-arm mailing list