On Thu, 2012-11-08 at 16:58 +0100, Radek Vykydal wrote:
The case:
1) Dracut does not use network so it does not write any ifcfg file
(e.g. DVD install)
2) NM creates default auto connection (DHCP) because it can't find
any ifcfg file for a device.
3) Anaconda writes out default ifcfg file (e.g. ifcfg-eth0)
4) When editing a connection in nm-c-e, ifcfg file of edited default
auto connection (Wired connection 1) is created
(ifcfg-Wired_connection_1).
5) If anaconda tweaks any ifcfg file later (setting ONBOOT, NM_CONTROLLED),
it is the ifcfg-eth0.
6) Both ifcfg files are copied to the target system at the end of
installation
Looks good to me.
--
Vratislav Podzimek
Anaconda Rider | Red Hat, Inc. | Brno - Czech Republic