Nevermind, after updating the firmware it started working again, weird that
though, the older cura had no problem, but even downgrading to the cura-lulzbot
released at F27 GA I was not able to talk to the printer anymore ...
Simo.
On Thu, 2018-04-19 at 12:12 -0400, Simo Sorce wrote:
I just updated to 2.6.69 from testing after tryin the latest stable
and I have
to report that it does not seem to recognize my Lulzbot Mini.
It tries to connect and then brings up a warning that the wrong printer has
been detected.
I have to say the new UI is really visually bad compared to the previous one,
but it has more knobs so I am trying to convince myself it is OK, but I would
like also to be able to actually print.
Ideas ?
Simo.
On Tue, 2018-01-09 at 16:39 -0500, Tom Callaway wrote:
> I'm ready to update the cura-lulzbot stack (and firmware), but in order
> to do that, I need to get python-uranium-lulzbot into Fedora. The
> package review is here:
>
>
https://bugzilla.redhat.com/show_bug.cgi?id=1532837
>
> Thanks,
>
> ~tom
> _______________________________________________
> 3dprinting mailing list -- 3dprinting(a)lists.fedoraproject.org
> To unsubscribe send an email to 3dprinting-leave(a)lists.fedoraproject.org
--
Simo Sorce
Sr. Principal Software Engineer
Red Hat, Inc
_______________________________________________
3dprinting mailing list -- 3dprinting(a)lists.fedoraproject.org
To unsubscribe send an email to 3dprinting-leave(a)lists.fedoraproject.org
--
Simo Sorce
Sr. Principal Software Engineer
Red Hat, Inc