On Thu, 2018-04-19 at 16:32 -0400, Tom Callaway wrote:
On 04/19/2018 12:45 PM, Simo Sorce wrote:
> Nevermind, after updating the firmware it started working again, weird that
> though, the older cura had no problem, but even downgrading to the cura-lulzbot
> released at F27 GA I was not able to talk to the printer anymore ...
Yeah, there is a firmware incompatibility with the latest stuff. Should
hopefully be a one-time thing.
It would be nice if the pop-up error could hint at upgrading the firmware as
something the user may want to look at if they think the error message is
Sr. Principal Software Engineer
Red Hat, Inc