On 12/1/20 8:34 PM, Fulko Hew wrote:
As the subject line asks, where's the best place to discuss
issues?
The 3dprinting list ?
Yes, 3dprinting(a)lists.fedoraproject.org
In the meantime, I've been using the released version of Cura on
F28
but I couldn't seem to get a slice that had 1 layer wide vertical walls.
So I thought I'd try the most recent version in F33 in a VM.
[I then had to upgrade a system to F33 rather than in a VM.]
After installing 'dnf install cura' and running it,
it hangs with a splash screen that says:
'Welcome to Ultimaker Cura.
Please follow these steps to set up Ultimaker Cura.
This will only take a few moments.'
And that's it. It does nothing else, and there isn't anything I can click on to
proceed.
Any suggestions?
No idea. What virtualization do you use? I've just tried Fedora 33 Workstation
in GNOME Boxes (Running on Fedora 33 Xfce Spin) and it worked for me.
There is a "Get started" button under the "...This will only take a few
moments." text. Maybe the VM screen is too small to make it visible, the window
is rather tall.
If that's not the case, could you launch cura from the terminal and see if
there's some error in there?
--
Miro Hrončok
--
Phone: +420777974800
IRC: mhroncok